Back to the list of connectors

Extreme Networks (SNMP)

Description

This connector discovers the Extreme Network switch enclosure as well as various environment sensors (temperatures, fans, power supplies). It relies on the SNMP protocol.

Connector file name: MS_HW_ExtremeNetworks.hdf

This connector supersedes:

Target

Typical platform: Extreme

Operating system: Network Device

Prerequisites

Leverages: SNMP Agent

Technology and protocols: SNMP

This connector is not available for the local host (it is applicable to remote hosts only).

Connector Activation Criteria

The Extreme Networks (SNMP) connector will be automatically activated, and its status will be reported as OK if all the below criteria are met:

  • An SNMP Get-Next on the OID 1.3.6.1.2.1.2.2.1 must return a value in the same subtree
  • An SNMP Get-Next on the OID 1.3.6.1.4.1.1916.1 must return a value in the same subtree

Monitors

Object Type Collected Parameters Discovered Properties
Enclosure (MS_HW_ENCLOSURE)
  • Status
  • Serial Number
  • Type
  • Vendor
Fan (MS_HW_FAN)
  • Speed
  • Status
    Network Card, FC Port (MS_HW_NETWORK)
    • Bandwidth Utilization
    • Error Percent
    • Link Speed
    • Link Status
    • Received Bytes Rate
    • Received Packets Rate
    • Status
    • Transmitted Bytes Rate
    • Transmitted Packets Rate
    • Device Type
    • Physical Address
    • Physical Address Type
    Power Supply (MS_HW_POWERSUPPLY)
    • Status
    • Additional Information 1
    • Power (Nominal)
    • Power Supply Type
    Temperature Sensor (MS_HW_TEMPERATURE)
    • Status
    • Temperature
      Keywords:
      hardware hdf patrol connectors
      No results.