Back to the list of connectors

IBM BladeCenter Management Module

Description

This connector enables hardware monitoring for IBM BladeCenter chassis through the IBM BladeCenter Management Module (SNMP-based). Needs to run remotely.

Connector file name: MS_HW_IBMBlade.hdf

Target

Typical platform: IBM BladeCenter

Operating system: Out-of-Band

Prerequisites

Leverages: IBM BladeCenter Management Module

Technology and protocols: SNMP

This connector is not available for the local host (it is applicable to remote hosts only).

Connector Activation Criteria

The IBM BladeCenter Management Module connector will be automatically activated, and its status will be reported as OK if all the below criteria are met:

  • An SNMP Get-Next on the OID 1.3.6.1.4.1.2.3.51.2.2.1.1.2 must return a value in the same subtree

Monitors

Object Type Collected Parameters Discovered Properties
Enclosure (MS_HW_ENCLOSURE)
  • Power Consumption
  • Additional Information 1
  • Additional Information 2
  • Model
  • Serial Number
  • Type
  • Vendor
Blade (MS_HW_BLADE)
  • Power State
  • Status
  • Additional Information 1
  • Additional Information 2
  • Blade Model
  • Blade Name
  • Serial Number
Fan (MS_HW_FAN)
  • Speed Percent
  • Status
  • Speed Percent Warning Threshold
Other Device (MS_HW_OTHERDEVICE)
  • Status
  • Additional Information 1
  • Additional Information 2
  • Additional Information 3
  • Device Type
Power Supply (MS_HW_POWERSUPPLY)
  • Status
  • Additional Information 1
  • Power Supply Type
Temperature Sensor (MS_HW_TEMPERATURE)
  • Status
  • Temperature
  • Alarm Threshold
  • Warning Threshold
Voltage Sensor (MS_HW_VOLTAGE)
  • Voltage
  • Lower Threshold
  • Upper Threshold
  • Voltage Type
Keywords:
hardware hdf patrol connectors
No results.